1. Start with your nails already polished and cured using gelmoment products.
2. Remove the blue protective film on the stamping plate before use.
3. Select a design that you would like to transfer from a stamping plate to your nail.
4. Select the stamping gel colour you would like to use for your design.
5. Apply a thin strip/line of stamping gel along the short edge of the chosen design.
6. Use the Scraper at a 45-degree angle to pull the stamping gel across the design. Repeat this step to remove any excess stamping gel, until the design can be clearly seen on the stamping plate.
7. To capture the design, roll the soft end of the Stamper over the chosen design on the plate. Start from one side of the plate and roll the stamper over it to the other side. The stamping gel design should be clearly visible on the silicone stamper head.
8. To transfer the design, roll the stamper over your painted nail in the desired location. Move the stamper from one side of the nail to the other by pressing firm enough to transfer the design, but not too firmly to smudge it. Lift the stamper away from the nail and ensure the design is positioned on the nail as desired. Use gelmoment cleansers to wipe off any corrections before curing.
9. Cure your completed design under a gelmoment LED lamp. For an extra layer of protection, apply one coat of clearly frisky gel polish over the design and cure again.
o To clean the stamping plates, use a gelmoment remover pad.
Stamp gel polish designs onto any gelmoment manicure!
Whether for a full manicure or accent nails, a little pattern goes a long way with this stamping plate. For lovers of plaid, stripes, hound’s tooth & more.
1. Start with your nails already polished and cured using gelmoment products.
2. Remove the blue protective film on the stamping plate before use.
3. Select a design that you would like to transfer from a stamping plate to your nail.
4. Select the stamping gel colour you would like to use for your design.
5. Apply a thin strip/line of stamping gel along the short edge of the chosen design.
6. Use the Scraper at a 45-degree angle to pull the stamping gel across the design. Repeat this step to remove any excess stamping gel, until the design can be clearly seen on the stamping plate.
7. To capture the design, roll the soft end of the Stamper over the chosen design on the plate. Start from one side of the plate and roll the stamper over it to the other side. The stamping gel design should be clearly visible on the silicone stamper head.
8. To transfer the design, roll the stamper over your painted nail in the desired location. Move the stamper from one side of the nail to the other by pressing firm enough to transfer the design, but not too firmly to smudge it. Lift the stamper away from the nail and ensure the design is positioned on the nail as desired. Use gelmoment cleansers to wipe off any corrections before curing.
9. Cure your completed design under a gelmoment LED lamp. For an extra layer of protection, apply one coat of clearly frisky gel polish over the design and cure again.
o To clean the stamping plates, use a gelmoment remover pad.